Rule · CMS calculator

The no-clash rule for cleats

published

cms.rule.noClash

How close two cleats, or a cleat and a cable, may stand across a rung. Two bodies on the same rung need a full body each; on different rungs, half of each plus half the other's cable; a body against a loose cable, half and half; two loose cables, half a diameter each — and any clearance you set, wherever a body is involved.

Local graph

Leans on · 1Leaned on by · 2Cleat catalogue — fed by, publishedCleat cataloguefed byFill by width — feeds, publishedFill by widthfeedsCleat bolts in the rung slots — feeds, estimatedCleat bolts in the rung slotsfeedsThe no-clash rule forcleats Leans on · 1Leaned on by · 2Cleat catalogue — fed by, publishedCleat cataloguefed byFill by width — feeds, publishedFill by widthfeedsCleat bolts in the rung slots — feeds, estimatedCleat bolts in therung slotsfeedsThe no-clashrule for cleats Leans on · 1Leaned on by · 2Cleat catalogue — fed by, publishedCleat cataloguefed byFill by width — feeds, publishedFill by widthfeedsCleat bolts in the rung slots — feeds, estimatedCleat bolts inthe rung slotsfeedsThe no-clash rule for cleats

publishedestimateda choiceno sourceArrows: the way the data flows

See it in the whole calculator

How the calculator uses it

It is ONE function. Laying out a cleated run, dragging a cleat in the rung editor and lining the cleats up with the slots all obey it, so the plan, the Section, the At a rung view and the 3-D cannot disagree. Nothing may stand past the future-spare line.

Worked through on the owner’s ladder run — 4 × XLPE/SWA/LSOH 4c 95mm², cleated on every rung

The size the engine chose600 mm wide
Its inside width596 mm
Usable, with 30 % kept clear417.2 mm
What the cleats and cables take368.0 mm
VerdictPASS

Computed by the calculator for this run when this page was generated — not typed.