Document · CMS calculator
2F+ two hole clamp — data sheet DS20E
publishedcms.doc.ellisDs20e
The current Ellis data sheet for the 2F+ two-hole nylon clamp — the two-bolt range the calculator proposes. Page 1 is the dimension table; page 2 the testing summary, with two short-circuit tests and the conditions each was made under.
Local graph
publishedestimateda choiceno sourceArrows: the way the data flows
The original document
- Publisher
- Ellis Patents
- Title
- Data sheet DS20E “2F+ two hole clamp”
- Edition
- issue 04, 30/09/26
- Where in it
- p.1 the dimension table; p.2 the testing summary
- Do we hold it
- downloaded from the maker
- May it be reproduced here
- In small extracts, quoted with acknowledgement. The document is the authority.
Ellis Patents — 2F two-hole clamp ↗ We are not the source of record.
What the document says


How the calculator uses it
The cleat catalogue takes every two-bolt part's HEIGHT and BOLTS from page 1, which is why the 1200, 1201 and 1202 parts are on M10 although the older catalogue printed M12. The declarations carry page 2's tests, read as peak currents — the conservative reading — and the lower one bounds the duty the check reports.
Watch for
A declaration is a duty the cleat survived at a stated spacing, cable and phase spacing — not a spacing selection, and not a pass.
Where the sources disagree
- Cleat catalogue 001816-3 — supersedes: heights and bolts of the two-bolt range